- All output is written to standard output.
- Output is a text file, with each line terminated by linefeeds.
F1 sclkvalue dist pos frac flag inc ems phs [otherdata] sclkvalue dist pos frac flag inc ems phs [otherdata] .. F2 sclkvalue dist pos frac flag inc ems phs [otherdata] sclkvalue dist pos frac flag inc ems phs [otherdata] F3 F4 .. FN END
Where:
- FN is a facet identifier that identifies facet number N. Each sclkvalue that meets the distance criteria for facet number N is listed sequentially after the facet identifier. If no sclk values meet the distance criteria, then no values are listed, and the next facet identifier follows on the next line. sclkvalue is the sclk exactly as it appeared in the input file.
- dist is a real number that describes the distance of the spot from the center of the facet in units of milliradians.
- pos is the position angle of the center of the instrument boresight intersection on the surface measured in degrees from North, with East being 90 degrees.
- frac is a real number greater than or equal to 0.0 and less than or equal to 100.0 that describes the fraction of the facet covered by the spot. If the value is 0.0, then the spot does not cover any portion of the facet. If the value is 100.0 then the facet is entirely covered by the spot.
- flag is 1 if any portion of the spot does not intersect the surface of Bennu, otherwise it is 0.
- inc is the incidence angle in degrees
- ems is the emission angle in degrees
- phs is the phase angle in degrees
- [otherdata] is all textual data on the line following the sclk value, up to the linefeed, unchanged.