= Test11J: =
Building topography with s/c azimuth every 90deg and 5cm images.

= Results Summary: =
Maplet continues to change even after 150 iterations. I am not sure why CompareOBJ gives such low numbers for the first few steps; as you can see the boulder is basically flat. Note that once I started using auto alignment the top of the boulder dropped down a bit.

= RMS values: =
||STEP||COMPAREOBJ(km)(w/ opt trans and rot)|| compMapVec(m)||NOTES||
||step01||2.190268134923605E-5||0.31365967||aligned images by hand||
||step02||3.5256309619938184E-5||0.27947998||
||step03||4.485187310672082E-5||0.25335693||
||step05||5.7255698178525545E-5||0.21551514||
||step10||5.492866645009829E-5||0.16952515||
||step15||5.1062863891161054E-5||0.14590454||
||step20||4.7622820814694255E-5||0.12872314||
||step30||4.269721397225718E-5||0.10583496||
||step31||4.227573844341813E-5||0.10379028||autoalign from here down||
||step32||4.175892924186137E-5||9.33227539E-02||
||step40||3.875789043105787E-5||7.29064941E-02||
||step50||3.49730399013492E-5||6.76269531E-02||
||step100||2.5211635256156916E-5||4.28161621E-02||

= Traces: =
{{attachment:out1_combined.png}}

= Landmark Display: =
step01 {{attachment:step01_display.jpg}}step01 {{attachment:step150_display.jpg}}