Block 13 - BuildShape V2

Description

Steps to build, review and install a shape model

Procedure

Set-up

Bob uses a copy/paste technique that is normally held in a support file densify-cut paste. I've created a script in /opt/local/spc/bin called buildShape.sh <version> that will do the same thing in batch. It also runs view_shape to make the 8 views of the object for easy evaluation.

   buildShape.sh farV01

When this is done, you will have

• dum-far320v1
• shape-far320v1-64
• shape-far320v1-128
• shape-far320v1-256
• shape-far320v1-512
• shape.log. A log file that saves the commands and output

Evaluate Final Results

Check to see if the offset of the centroid from the center of the system is less than the required criteria (suggest 1/2 image pixel).

   shape_info
     shape-far320v1-128

If you need to shift it, run the shift command. If you do this, you should close out this blockFinish because you will redo the build routine fully.

   shift
   -OffsetX -OffsetY -OffsetZ
   y
   shape-far320v1-128
   n
   y

   geometry
   20
   1
   n
   n

Once that is done, you should iterate on it at least once and rebuild the shape (go back to the top of this procedure until the shift is less than the criteria.

Install Shape

   relink shape-far320-128 SHAPE.TXT
   evalReg.sh lsupport/theEight

Finish the Block

  echo 9 | blockFinish far\

(Compiled by EEP)