Block 13 - BuildShape V2

Description

Steps to build, review and install a shape model

Procedure

Set-up

Bob uses a copy/paste technique that is normally held in a support file densify-cut paste. I've created a script in /opt/local/spc/bin called buildShape.sh <version> that will do the same thing in batch. It also runs view_shape to make the 8 views of the object for easy evaluation.

To make the script easier, set this variable

ID=farV03
echo "Building the shape with suffix $ID" | tee -a notes

Running

This is a script in /opt/local/spc/bin that will dumb down a model, then build it back up using maplets.

• buildShape.sh $ID

When this is done, you will have

• dum-far320v1
• shape-far320v1-64
• shape-far320v1-128
• shape-far320v1-256
• shape-far320v1-512
• shape.log -- A log file that saves the commands and output

Albedo

• If you want albedo, you run densifyA. If you just want to add albedo only for the most recent model, then you can use the existing previously generated script from buildShape.sh

  • densifyA < tmpRun.txt | tee -a shape.log

Evaluate Final Results

Check to see if the offset of the centroid from the center of the system is less than the required criteria (suggest 1/2 image pixel).

• echo SHAPEFILES/shape-$ID-512 | shape_info | tee -a notes

Install Shape

If you like the results, you can instal the model. Review the red/blue or side-by-side images to ensure the model is good. If it isn't then uninstall the model.

• cd SHAPEFILES
  relink.sh shape-$ID-512 SHAPE.TXT | tee -a ../notes
  cd ..
  evalReg.sh lsupport/theEight

Finish the Block

Once that is done, you should iterate on it at least once and rebuild the shape (go back to the top of this procedure until the shift is less than the criteria.

• echo 9 | blockFinish far\

(Compiled by EEP)