|
Size: 1225
Comment:
|
Size: 1482
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 11: | Line 11: |
| Set the ID | Set the ID. This should be the current ID, not the new one (which will really just be moved) |
| Line 14: | Line 15: |
| echo "Shifting the model, ID = $shapeVar" >> notes | echo "Shifting the model, $ID = shapeVar" | tee -a notes |
| Line 22: | Line 23: |
| echo shape-$ID=512 | shape_info | tee -a ../notes cp shape-$ID-512 shift-far320v1.txt |
echo shape-$ID-512 | shape_info | tee -a ../notes cp shape-$ID-512 shift-$ID.txt |
| Line 32: | Line 33: |
| Notice, the shape model cannot have the .TXT at the end with the [[shift]] program. | |
| Line 35: | Line 37: |
| shift | /usr/local/bin/shift |
| Line 38: | Line 40: |
| shift-far320v1 | shift-<whatever> |
| Line 56: | Line 58: |
| relink shift-$ID.txt SHAPE.TXT | tee -a notes | echo shift-$ID.txt | shape_info | tee -a ../notes relink.sh shift-$ID.txt SHAPE.TXT | tee -a ../notes |
| Line 60: | Line 63: |
=== Finish the Block === While this completes the block, you still need to do the following procedures to make the shape model solid * [[Block 5 - Iterate v2]] * [[Block 13 - BuildShape v2]] |
|
| Line 75: | Line 72: |
=== Continue the process === While this completes the block, you still need to do the following procedures to make the shape model solid * [[Block 5 - Iterate v2]] * [[Block 13 - BuildShape v2]] |
Block 14 - Shift V2
Description
If the model has more than <criteria> of deviation from the center of figure, then shift it to be centered
Procedure
Set-up
Set the ID. This should be the current ID, not the new one (which will really just be moved)
ID=farV03 echo "Shifting the model, $ID = shapeVar" | tee -a notes
Record the current offset and make a new model that will be adjusted
cd SHAPEFILES echo shape-$ID-512 | shape_info | tee -a ../notes cp shape-$ID-512 shift-$ID.txt cd ..
Run the shift command.
(Comment -- Unsure if the shape needs to be installed before geometry is run) Notice, the shape model cannot have the .TXT at the end with the shift program.
murphy /usr/local/bin/shift OffsetX OffsetY OffsetZ y shift-<whatever> n y geometry 20 1 n n
Install Shape
Install the shape and review the fit to our main images
cd SHAPEFILES echo shift-$ID.txt | shape_info | tee -a ../notes relink.sh shift-$ID.txt SHAPE.TXT | tee -a ../notes cd .. evalReg.sh lsupport/theEight
Finish the Block
echo 11 | blockFinish far\
Continue the process
While this completes the block, you still need to do the following procedures to make the shape model solid
(Compiled by EEP)