Differences between revisions 2 and 5 (spanning 3 versions)

Block 14 - Shift V2

Description

If the model has more than <criteria> of deviation from the center of figure, then shift it to be centered

Procedure

Set-up

Set the ID

ID=farV03
echo "Shifting the model, ID = $shapeVar" >> notes

Record the current offset and make a new model that will be adjusted

cd SHAPEFILES
echo shape-$ID=512 | shape_info | tee -a ../notes
cp shape-$ID-512 shift-$ID.txt
cd ..

Run the shift command.

(Comment -- Unsure if the shape needs to be installed before geometry is run) Notice, the shape model cannot have the .TXT at the end with the shift program.

murphy
shift
OffsetX OffsetY OffsetZ
y
shift-<whatever>
n
y

geometry
20
1
n
n

Install Shape

Install the shape and review the fit to our main images

cd SHAPEFILES
relink shift-$ID.txt SHAPE.TXT | tee -a notes
cd ..
evalReg.sh lsupport/theEight

Finish the Block

```
echo 11 | blockFinish far\
```

Continue the process

While this completes the block, you still need to do the following procedures to make the shape model solid

(Compiled by EEP)

-  ⇤ ← Revision 2 as of 2018-11-20 16:59:43 → 
  Size: 1225
  Editor: EricPalmer
  Comment:
+   ← Revision 5 as of 2018-11-21 11:41:54 → ⇥
  Size: 1319
  Editor: EricPalmer
  Comment:
-Deletions are marked like this.
+Additions are marked like this.
 Line 23:
-cp shape-$ID-512 shift-far320v1.txt
+cp shape-$ID-512 shift-$ID.txt
 Line 32:
+Notice, the shape model cannot have the .TXT at the end with the [[shift]] program.
-Line 38:
+Line 39:
-shift-far320v1
+shift-<whatever>
-Line 61:
+Line 62:
-=== Finish the Block ===
While this completes the block, you still need to do the following procedures to make the shape model solid
   * [[Block 5 - Iterate v2]]
   * [[Block 13 - BuildShape v2]]
-Line 75:
+Line 70:
+=== Continue the process ===
While this completes the block, you still need to do the following procedures to make the shape model solid
   * [[Block 5 - Iterate v2]]
   * [[Block 13 - BuildShape v2]]