|
Size: 1225
Comment:
|
Size: 1373
Comment:
|
| Deletions are marked like this. | Additions are marked like this. |
| Line 22: | Line 22: |
| echo shape-$ID=512 | shape_info | tee -a ../notes cp shape-$ID-512 shift-far320v1.txt |
echo shape-$ID-512 | shape_info | tee -a ../notes cp shape-$ID-512 shift-$ID.txt |
| Line 32: | Line 32: |
| Notice, the shape model cannot have the .TXT at the end with the [[shift]] program. | |
| Line 38: | Line 39: |
| shift-far320v1 | shift-<whatever> |
| Line 56: | Line 57: |
| relink shift-$ID.txt SHAPE.TXT | tee -a notes | echo shift-$ID.txt | shape_info | tee -a ../notes relink shift-$ID.txt SHAPE.TXT | tee -a ../notes |
| Line 60: | Line 62: |
=== Finish the Block === While this completes the block, you still need to do the following procedures to make the shape model solid * [[Block 5 - Iterate v2]] * [[Block 13 - BuildShape v2]] |
|
| Line 75: | Line 71: |
=== Continue the process === While this completes the block, you still need to do the following procedures to make the shape model solid * [[Block 5 - Iterate v2]] * [[Block 13 - BuildShape v2]] |
Block 14 - Shift V2
Description
If the model has more than <criteria> of deviation from the center of figure, then shift it to be centered
Procedure
Set-up
Set the ID
ID=farV03 echo "Shifting the model, ID = $shapeVar" >> notes
Record the current offset and make a new model that will be adjusted
cd SHAPEFILES echo shape-$ID-512 | shape_info | tee -a ../notes cp shape-$ID-512 shift-$ID.txt cd ..
Run the shift command.
(Comment -- Unsure if the shape needs to be installed before geometry is run) Notice, the shape model cannot have the .TXT at the end with the shift program.
murphy shift OffsetX OffsetY OffsetZ y shift-<whatever> n y geometry 20 1 n n
Install Shape
Install the shape and review the fit to our main images
cd SHAPEFILES echo shift-$ID.txt | shape_info | tee -a ../notes relink shift-$ID.txt SHAPE.TXT | tee -a ../notes cd .. evalReg.sh lsupport/theEight
Finish the Block
echo 11 | blockFinish far\
Continue the process
While this completes the block, you still need to do the following procedures to make the shape model solid
(Compiled by EEP)